GoShikenのCiscoの300-420試験トレーニング資料は豊富な経験を持っているIT専門家が研究したもので、問題と解答が緊密に結んでいるものです。Ciscoの300-420試験トレーニング資料は現在、市場上で一番質のいい学習教材です。GoShikenは無料でサンプルを提供することができる。うちの学習教材は君の認定試験に合格することに大変役に立ちます。
Cisco 300-420試験は90分間のテストで、60〜70の多肢選択問題で構成されています。試験に合格するためには、候補者は複雑なエンタープライズレベルのネットワークの設計と実装の能力を示さなければなりません。試験は英語と日本語で利用可能で、世界中のPearson VUEテストセンターで受験することができます。この試験に合格することは、ITプロフェッショナルが現代のビジネスのニーズを満たす複雑なエンタープライズネットワークを設計・実装するために必要なスキルと知識を持っていることを示します。
合格できるCisco Designing Cisco Enterprise Networks試験はいくつありますか? それらをすべて試してみてください! GoShikenは、Designing Cisco Enterprise Networks コーススペシャリストが開発した実際のCisco 300-420の回答を含むDesigning Cisco Enterprise Networks 300-420試験問題への完全なアクセス権をUnlimited Access Planに提示します。 Cisco Designing Cisco Enterprise Networksテストに合格できるだけでなく、さらに良くなります! また、すべての試験の質問と回答にアクセスして、合計1800以上の試験に合格することもできます。
Cisco 300-420試験は、60〜70の複数選択質問を含む90分のテストです。この試験は英語で実施されており、世界中のピアソンVUEテストセンターで入手できます。試験料は300米ドルで、認定は3年間有効です。試験に合格した候補者は、Cisco Certified Design Professional(CCDP)認定を取得します。
シスコ300-420試験は、エンタープライズレベルのネットワークを設計する専門家の知識と技能をテストする厳しい認定試験です。この試験に合格することは、シスコテクノロジーを使用してスケーラブルで安全で効率的なネットワークを構築する候補者の専門知識を証明します。この認定を取得することで、候補者はキャリアを前進させ、ネットワークエンジニアリングの分野でより難しい役割を担うことができます。
質問 # 33
Refer to the exhibit. An engineer is designing a BGP solution for a client that peers with ISP1 for full Internet connectivity and with ISP2 for direct exchange of routes for several third parties. Which action, when implemented on the edge routers, enables the client network to reach the Internet through ISP1?
正解:C
質問 # 34
In what mode does an LWAPP-enabled access point operate?
正解:A
解説:
Lightweight access point protocol (LWAPP)-enabled access points operate in lightweight mode. LWAPP is a protocol used to allow centralized management of APs. The management components are removed from the APs, and a WLAN controller provides a single point of management. This controller coordinates WLAN access, managing the load on the APs and user movement between APs. Upon starting, an LWAPP-enabled access point must obtain an IP address. It can then discover the controller using DHCP, DNS, or a subnet broadcast. When multiple wireless controllers are detected by an AP, it chooses to associate with the controller that has the fewest existing associated APs.
Individually configured APs that operate without central management are operating in autonomous mode. This would be the opposite of lightweight mode, which is made possible by LWAPP. Autonomous access points can be upgraded to lightweight. If they are upgraded, they will only function in conjunction with a WLAN controller.
Moreover, when an autonomous access point is upgraded to lightweight, the console port only provides read access to the unit.
Characteristics that autonomous and lightweight access points have in common:
Both support Power over Ethernet (PoE)
Both can use a Cisco Secure Access Control server (ACS) for security
A wireless gateway bridge (WGB) is used to connect a computer without a wireless network card to a wireless network, but not separate WLANs. The WGB can connect up to eight computers to a WLAN. The WGB connects to the root AP through a wireless interface.
Ad hoc is a WLAN mode used for peer-to-peer connectivity. Ad hoc mode allows wireless-enabled computers to communicate with each other without having an AP involved.
Objective:
Layer 2 Technologies
Sub-Objective:
Configure and verify other LAN switching technologies
References:
Cisco > Support > Product Support > Wireless > Cisco Aironet 1200 Series > Reference Guides > Technical References > Upgrading Autonomous Cisco Aironet Access Points to Lightweight Mode Cisco > Support > Technology Support > Wireless/Mobility > Wireless, LAN (WLAN) > Design > Design Technotes > Cisco Wireless Devices Association Matrix
質問 # 35
Refer to the exhibit.
EIGRP has been configured on all links. The spoke nodes have been configured as EIGRP stubs, and the WAN links to R3 have higher bandwidth and lower delay than the links to R4. When a link failure occurs at the R1-R2 link, what happens to traffic on R1 that is destined for a subnet attached to R2?
正解:A
質問 # 36
An ISP provides Layer 3 VPN service over MPLS to a customer with four branches and multiple CE routers at each branch. To exchange the routes that are learned from the CE routers, which BGP address family should the ISP activate among the PE routers?
正解:A
質問 # 37
A client is moving to Model-Driven Telemetry and requires periodic updates. What must the network architect consider with this design?
正解:D
解説:
Section: Automation
質問 # 38
......
300-420資料的中率: https://www.goshiken.com/Cisco/300-420-mondaishu.html